Siding, Soffit, and Fascia Repair in Jacksonville, FL

A lot of siding, soffit, and fascia damage in the Jacksonville area comes down to moisture getting somewhere it shouldn't be. Florida's wet season runs roughly from June through September, and the combination of heavy rain, standing water, and heat creates ideal conditions for wood to soften and fail. Here's a closer look at what we repair most often.

Vinyl siding repair: Vinyl is a common siding material on homes in Greater Jacksonville built after the mid-1980s. It holds up well until a string trimmer clips the bottom courses, shattering them, or until the sun bleaches a section, making it brittle. We replace individual panels or sections, and we'll pull old siding from a less-visible spot on the house, like the back of a garage, and use it as the patch if color matching is a concern. New vinyl of the same spec won't match weathered panels, so this swap approach is often the cleanest fix.

Fiber cement and Hardie board repair: Fiber cement siding, including James Hardie products, is popular in Ponte Vedra Beach, Saint Johns, and other parts of Northeast Florida, where homeowners want a low-maintenance wood look. It doesn't rot, but it can crack at the edges if it wasn't properly back-primed and caulked during installation, and impact damage from hail or debris leaves clean holes that need to be matched and patched. We cut out the damaged section, install a new piece of the same profile, prime all cut edges, and caulk before painting.

Plywood and T1-11 siding repair: Older homes in Atlantic Beach, Neptune Beach, and Jacksonville Beach often have plywood or T1-11 siding. Without gutters and regular paint, the bottom courses delaminate and go soft. We replace the damaged sections, ensure the new material is back-sealed before it goes up, and recommend installing gutters if there isn't a system in place. Plywood siding that's kept painted and caulked lasts, but neglected areas deteriorate fast in the Florida climate.

Wood siding repair: Cedar and other wood siding products need consistent paint or stain to hold up. When the finish fails, moisture gets in, and rot follows. We cut out affected boards, replace them with matching material, and prime all surfaces before finishing. Adjacent boards often need re-nailing or recaulking at the same time, so we look at the surrounding area rather than just pulling one piece.

Soffit repair: Soffits sit directly under the roofline overhang, which puts them in the path of any water that runs off the edge and splashes back. They also provide ventilation to the attic space, so damaged or missing soffit vents can lead to heat buildup and pest infestations. We repair and replace wood and vinyl soffit panels, replace torn or rusted vent screens, and re-anchor sections that have blown loose from their channels. If there's rot behind the soffit panel, we address the wood framing before closing it back up.

Fascia board repair: Fascia boards run along the roofline and anchor the gutters. Water backs up behind clogged gutters and sits against the fascia for days at a time, which is why fascia rot is so common in Greater Jacksonville. We replace rotted fascia sections, re-prime and paint the new wood, and resecure or reset gutters after the repair. Catching fascia damage early keeps the repair simple. Waiting usually means the rot has worked into the rafter tails, which turns a one-hour job into a half-day one.